Publicité
Check the screws and tighten if necessary.
u While changing over the door hinges, observe the safety
instructions above and also the information in the symbols
key.
Change the hinges over as shown at the end
of the book.
9 Installing the appliance in the
recess
WARNING
Fire hazard from short-circuiting!
u When pushing the appliance into the recess, take care not to
crush, jam or damage the mains power cable.
u Do not operate the appliance with a defective mains power
cable.
NOTICE
Risk of damaging the hinges!
If when being pushed the appliance is held by the door, the
hinges could be damaged.
u When pushing or otherwise moving the appliance, always
hold it by the main body.
For installation in the recess, the following accessories are
available from Customer Service:
Kit to limit the door opening angle to
90°
Set for fitting split furniture front
panels
Set with covers for concealed hinges
There is a risk of injury during this stage! Please
observe the safety instructions!
The instructions apply to several models. Only carry
out this step if the appliance is equipped with the
corresponding feature.
Choose between the alternatives given.
Loosen the screws only, do not undo them all the way.
Check the screws and tighten if necessary.
u Please take note of the information in the symbols key
during installation.
* Depending on model and options
Installing the appliance in the recess
Install the appliance in the recess as shown at
the end of the booklet.
10 Disposing of packaging
WARNING
Danger of suffocation due to packing material and plastic film!
u Do not allow children to play with packing material.
The packaging is made of recyclable materials:
-
corrugated board/cardboard
-
expanded polystyrene parts
-
polythene bags and sheets
-
polypropylene straps
nailed wooden frame with polyethylene panel*
-
u Take the packaging material to an official collecting point.
11 Connecting the appliance
NOTICE
Failure to connect properly
Damage to the electronics.
u Do not use a standalone inverter.
u Do not use an energy saving plug.
WARNING
Failure to connect properly
Fire hazard.
u Do not use an extension cable.
u Do not use distributor blocks.
The type of current (alternating current) and voltage at the
installation site have to conform with the data on the type plate .
The socket must be properly earthed and fused. The tripping
current for the fuse must be between 10 A and 16 A.
The socket must be easily accessible so that the appliance can
be quickly disconnected from the supply in an emergency. It
must be outside the area of the rear of the appliance.
u Check the electrical connection.
u Plug in the power plug.
13
Publicité
