Télécharger Imprimer la page

Atag KD80178DN Instructions De Montage page 12

Publicité

Ventilation of the kitchen unit
The unit doors must be planar and mounted stress-free.
-
NOTICE
Risk of damage from over-heavy unit door!
If the unit door is too heavy, damage to the hinges and resulting
impairment of function cannot be excluded.
u Before mounting the unit door, make sure that the door does
not exceed the approved unit door weight.
Appliance model
KD80178DN
7 Ventilation of the kitchen unit
-
There must be an effective ventilation shaft of at least
200 cm
per appliance at the air inlet
2
Fig. 3 (B) vent.
-
The principle applies that the larger the ventilation shaft, the
more energy-saving the operation of the appliance.
12
Maximum cabinet door weight
(kg)
Refrigerator
Freezer
section door
section door
17
12
Fig. 3 (A) and outlet
-
The upper ventilation shaft can either be positioned directly
above the appliance with an optional ventilation grille
Fig. 4 (C) , close to the ceiling above the unit Fig. 4 (D) or as
an air outlet opening in a false ceiling
8 Changing over door hinges
CAUTION
Risk of injury if soft stop contracts!
u Carefully remove the soft stop mechanism.
CAUTION
Risk of injury if hinges fold!
u Leave hinges open.
WARNING
Risk of injury due to the door dropping out!
If the fastening parts are not screwed into place firmly enough,
the door may drop out. This may lead to severe injuries. What is
more, the door may not close and therefore the appliance may
fail to cool properly.
u Screw the hinges and the ball journal of the soft stop mecha-
nism firmly into place, with 4 Nm.
u Screw the holder of the soft stop mechanism firmly into
place, with at least 3 Nm.
u Check all of the screws and retighten if necessary.
Fig. 3
Note
The door hinges can only be changed over if there is sufficient
space towards the top to pull out the hinge mounting bracket
and to mount it again on the other side. This is generally not the
case after installation in the recess.
u Change the hinges over before the appliance is installed in
the recess.
There is a risk of injury during this stage! Please
observe the safety instructions!
The instructions apply to several models. Only carry
out this step if it is relevant for your appliance.
Choose between the alternatives given.
Loosen the screws only, do not undo them all the way.
Fig. 4 (E) .
* Depending on model and options
Fig. 4

Publicité

loading