Publicité
4 Appliance dimensions
A
(mm)
KD80178DN
559
5 Recess dimensions
The appliance is built-in and therefore completely enclosed by
a kitchen unit. The kitchen unit concerned must be built exactly
to the prescribed dimensions and allow for sufficient ventilation,
both at air inlet and outlet, to ensure proper appliance opera-
tion.
* Depending on model and options
Fig. 1
B
C
D
E
(mm)
(mm)
(mm)
(mm)
544
1770
695
15
Appliance dimensions
Fig. 2
F
G
(mm
(mm
)
)
KD80178DN
1772
560
—
—
1788
570
The specified energy consumption applies to a unit depth of
560 mm. The appliance will work properly at a unit depth of 550
mm, but at a slightly higher energy consumption.
u Check the wall thickness of the adjoining cabinets: it must
be min. 16 mm.
u Only install the appliance in robust, stable kitchen units.
Secure the units against tipping.
u Align the kitchen unit using a spirit level and marking square
and if necessary compensate with shims.
u Ensure that the floor and walls of the unit are at right angles
to one another.
6 Unit door
Two doors are required for this kitchen unit: the upper for the
-
refrigerator and the lower for the freezer compartment.
-
The doors must be minimum 16 mm and maximum 19 mm
thick.
When both doors are closed, the gap between the upper
-
and lower door must be at least 3 mm high.
-
The gap between unit doors must be at the same level as
the gap between the appliance doors.
-
There must be a gap of minimum 3 mm in height between
the door and the unit door located above it (if one exists).
-
The width of the unit doors depends on the style of the
kitchen and on the gap size between the door panels of the
cabinet. Generally, there should remain a vertical gap of
3 mm between the unit doors.
-
The top edges of the upper and lower doors should be on a
level with the doors of the adjoining cabinet (or cabinets), if
there are other cabinets.
H (mm)
J
L
(mm
(mm
)
)
min.
550,
min.
max.
recom-
500
19
mended:
560
11
Publicité
