Publicité
STEP 7 (Figure #11)
Line up the pre drilled hole in the rear bedliner
sidewall and the existing hole in the truck box rear
"D" pillar sidewall. Place scrivet fastener (callout 3)
through both holes. PRESS DOWN FIRMLY on the
scrivet to seat it in place.
STEP 8 (Figure #12)
Find the end marked "DOWN" on the back side of
the tie down boot pockets (callout 5). Press tie
down boot pockets into the tie down holes on the
bedliner with the "DOWN" writing closest to the
floor. The boot pockets will snap into place.
ATTENTION:
Upon installation of the bedliner there may be some initial distortion which prevent the floor from lying
flat. Minor to moderate distortion is a normal occurrence from the installation process and/or storage
method.
December 10, 2015
www.mopar.com
Figure #11
Figure #12
5
590155
K6862431
Publicité
