Publicité
NOTE 4: If the RAM truck is equipped with a goose-
neck hitch mount in the bed, the bedliner needs to
be modified as referenced in Figure 7. These three
locations need to be cut using a 4" hole saw with
the dimple used as the locating point for the drill bit.
Remove the caps from the three corresponding
locations in the pickup truck bed before installation.
STEP 4 (Figure #9)
Place the bedliner in pickup box while holding one
side in the air. Slide the second side under the
pickup box rail while the first comes down to rest on
the floor of the pickup box. Make sure the front rail
of the bedliner is over the front rail of the pickup
box.
STEP 5 (Figure #10)
While standing at the rear of the truck lift the
bedliner floor in the center. Slide the unrestrained
side of the bedliner under the pickup box rail while
allowing the floor to lower.
STEP 6
Check the overall fit. It is important that the bedliner
fits securely in place under the bedrails.
December 10, 2015
www.mopar.com
Figure #10
4
Figure #7
Figure #9
590155
K6862431
Publicité
