Publicité
Bedliner Installation:
CAUTION: It is recommended that two (2) people install the bedliner to avoid damage to the
painted surfaces of the truck.
NOTE: if the front floor tie down plugs were not removed when cleaning the bed, remove them at this
time.
NOTE 1: If the Ram truck is equipped with the Mopar
approved cargo management rail system, the
bedliner needs to be modified as referenced in
Figure #4. Local areas of the bedliner sidewall need
to be removed as defined by scribe lines on the
backside of the bedliner. It may be necessary to
enlarge the cutouts 6mm (¼") on all sides to allow
for expansion and contraction of the bedliner during
extreme temperatures.
NOTE 2: If the RAM truck is equipped with the
Mopar approved power outlet in bed, the bedliner
needs to be modified as referenced in Figure #5.
The material marked with scribe lines needs to be
removed to allow for the bedliner to fit on trucks with
the outlet installed.
NOTE 3: If the RAM truck is not equipped with cargo
lamps or the cargo management rail system, the
light hole plugs (callout 4) will need to be installed
into the bedliner before installing the liner into the
truck. The plug is installed from the outside of the
bedliner. Ensure the flange that calls out "REAR" is
facing the rear of the bedliner. Push the plug into
the light hole cutout until plastic liner is seated
between the two rubber plug flanges.
December 10, 2015
www.mopar.com
Scribe lines for Rail System
2 Places on the 6'6" bed, 3 places on the 8' bed
Outside of bedliner
Figure #4
Figure #5
Scribe Lines for Power Outlet
Figure #6
590155
K6862431
3
Publicité
