Fastening The Prism En; Mounting The Milling Cutter En - Abicor Binzel BRS-LCi VW Mode D'emploi

6 Putting into operation
1
2
Fig. 4
6.1 Installation
 See Fig. 4 Putting into operation on page EN-8
1 Fasten the support (6) on a vibration-free working surface in the work area of the robot by means of four
screws (5).
6.2 Fastening the prism
 See Fig. 4 Putting into operation on page EN-8
1 Insert the prism (3) into the clamping device (2) from above.
2 Screw in the cylinder head screw (4).
6.3 Mounting the milling cutter
1
Fig. 5
NOTE
• Use only tools with a suitable width across flats when changing the milling cutter. Milling cutter seat -
1 Insert the milling cutter (1) into the clamping device (1).
2 Secure the milling cutter (1) by means of tools (2).
EN - 8
1
6
Cleaning unit
3
Clamping device
4
Putting into operation
Clamping device 2
Mounting the milling cutter
width 27, milling cutter - width 17.
2
5
Prism
5
Cylinder head screw M5x20
6
1 2
3
Tool 3
BRS-LCi VW
3
4
4 screws
Support
Tool