Lanaform WBPM-110 Mode D'emploi page 9

05 Body Posture During Measurement
Sitting Comfortably Measurement
2cm above
the wrist.
he cuffed
k or table
tly placed,
r too loose.
06 Taking Your Blood Pressure Reading
nce range
e that the
the moni-
be during
ore blood
n the cuff
ent if the
e the cuff
after the
mmended.
M-WBPM110-006.indd 9 M-WBPM110-006.indd 9
Do not place the cuff around your arm if the
arm has any inflammation, acute diseases,
infections skin wounds.
a Be seated with your feet flat on the floor,
and don't cross your legs.
b Place palm upside in front of you on a flat
surface such as a desk or table, with your
elbow resting on a chair or table
c The middle of the cuff should be at the lev-
el of the right atrium of the heart.
a After applying the cuff and your body is in a com-
fortable position, press the
All display characters are shown for self-test.
You can check the LCD display according to the
picture. Please contact the service center if seg-
ment is missing. See picture 6-1.
b Then the current memory bank is blink. See
picture 6-2. Press MEM
over to other bank. Confirm your selection by
pressing START button. The current bank
can also be confirmed automatically after 5
seconds with no operation.
c If the monitor has stored results, the LCD
will momentarily display the most recent one.
See picture 6-3. If no result has been stored,
zero will appear on LCD. See picture 6-4.
d Then the monitor starts to seek zero pres-
sure. See picture 6-5.
e Then the monitor inflates the cuff until suffi-
cient pressure has built up for a measurement.
Then the monitor slowly releases air from
the cuff and carries out the measurement.
Finally the blood pressure and pulse rate
will be calculated and displayed on the LCD
screen. The blood pressure classification
indicator and Irregular heartbeat symbol
(if any) will blink on the screen. See pic-
ture 6-6. The result will be automatically
stored in the monitor.
START button.
f After measurement, the monitor will turn off
automatically after 1 minute of no operation.
Alternatively, you can press the
ton to turn off the monitor manually.
button to change g During measurement, you can press
the
itor manually.
Please consult a health care professional for in-
terpretation of pressure measurements.
EN ∙ FR ∙ NL ∙ DE
START
START button to turn off the mon-
14/10/2021 11:33:21 14/10/2021 11:33:21
but-
9