Lanaform WBPM-110 Mode D'emploi page 7

television 25 Attention that changes or modification not ex-
y turning
couraged
e or more
26 Swallowing batteries and/or battery fluid can
antenna.
the equip-
utlet on a 27 If you are allergic to plastic/rubber, please don't
ch the re-
09. Setup And Operating Procedures
ced radio/
01 Battery Loading
ents with
neonates,
al testing
, children
When LCD shows battery symbol
place all batteries with new ones.
ffect the
Rechargeable batteries are not suit-
ents with able for this monitor.
low blood
Remove the batteries if the monitor will not
ere will be
be used for a month or more to avoid rel-
osition).
evant damage of battery leakage.
s who use
no pulse)
device for should get in your eyes, immediately rinse with plen-
n arrhyth- ty of clean water and contact a physician.
ture beats
, poor per-
diseases.
at the end of their usage.
or.
f the FCC 02 Clock And Date Adjustment
owing two
use harm-
ust accept
erference
M-WBPM110-006.indd 7 M-WBPM110-006.indd 7
pressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
be extremely dangerous. Keep the batteries
and the unit out of the reach of children and
disabled persons.
use this device.
a Open battery cover at the back of the monitor.
b Load two AAA size batteries. Please pay at-
tention to polarity.
c Close the battery cover.
Avoid the battery fluid to get in your eyes. If it
The monitor, the batteries and the cuff, must
be disposed of according to local regulations
a Once you install the battery or turn off the
monitor, it will enter Clock Mode, and LCD will
display time and date. See picture 2.
b While the monitor is in Clock Mode, press
the
neously for two seconds, then release the
buttons, the monitor will be in Clock and
Date Adjustment Mode.
c In Clock and Date Adjustment Mode, the time
format will blink at first. See picture2-1.
While time format is blinking, press the
button
The default time format is 24h.
d Press the button
(range is 2018~2099), month, day, hour and
minute will blink in turn. See picture2- 2&2-3
& 2-4 & 2-5 & 2-6. While the number is blink-
ing, press the button
number, keep on pressing the button
the number will increase faster.
e During adjusting clock and date, the monitor
, re-
will go back to Clock Mode automatically when
no button will be pressed within 60 seconds.
f You can turn off the monitor by press-
ing
blinking, then the time and date is confirmed.
EN ∙ FR ∙ NL ∙ DE
START and MEM button simulta-
MEM to change the time format.
START repeatedly, the year
MEM to increase the
START button when the minute is
14/10/2021 11:33:21 14/10/2021 11:33:21
MEM ,
7