Declaration Of Conformity - D+H ZA-0300-1-PLP Notice Originale

Shifting of Motor
1. Move out toothed rack about 10 ... 20 mm.
Disconnect drive from electric Voltage!
2. Take off drive unit and shift
3. Attention! Moving direction of drive is changed.
Drive cable on the shutdown pcb, switch
red (+) with black (-).
10 ... 20 mm
Shifting of drive cable
Disconnect drive from electric voltage!

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following directives:
2014/30/EU
Technical file at:
D+H Mechatronic AG, D-22949 Ammersbek
Dirk Dingfelder
Member of the Board
09.10.2017
99.824.29 2.0/11/17
Maik Schmees
Authorized signatory, Technical Director
Mounting informations
- Swivel radius of the drive must go free over entire
range of stroke. Otherwise, the toothed rack and
the suspension can be damaged
- Drives with a stroke of ≥800 mm must not be moun-
ted „hung up at the bottom" (e.g. bracket UK)
- Eyebolt has to be adjusted so, that the drive is
disconnected with closed flap through it's inside
stop position damping. Brackets can be damaged
by to rigid adjustment!
- Technical clarification is required with D+H in case
of only tensile force applications of more than 500N
- A programming should be done before
installation, because the drives can only be
programmed individually connected
- ZA-TM drives may not be connected with a
coupling shaft (VW).
A combination with a slave unit (ZM) is permitted
ZA-TM
ZA-TM
VW
Disposal
Electrical devices, accessories, batteries and packa-
ging should be sorted for environmental-friendly
recycling. Do not dispose electrical devices and
batteries into household waste!
Only for EC countries:
According the European Guideline 2012/19/EU for
waste electrical and electronic equipment and its
implementation into national right, electrcal devices
that are no longer usable must be collected separa-
tely and disposed of in an environmentally correct
manner.
English
ZA-TM
ZM
VW
7/16
ZA-1-PLP