Parkside 339140 1910 Instructions D'utilisation Et Consignes De Sécurité page 7

and, in particular, areas where
there is paint and dust fog.
Specific safety

instructions
Changes as a result of technical
Q
progress can be introduced
by the manufacturer without
prior notice and may not be
included in the Operating
Instructions.
Check the equipment before
Q
putting it into service to see that
it is complete, functions properly
and is air tight!
Never put a defective or non-
Q
functional piece of equipment into
service. Contact the manufacturer
or get the equipment checked by
a qualified technician.
Never stand on the equipment!
Q
Hold the hose when unrolling
Q
and rolling up so that the hose
cannot injure anyone while
swinging about.
Pay attention to the maximum
Q
working pressure of the hose.
Only operate the hose within
the given parameters (see
Technical data).
At very low temperatures the
Q
hose may become inflexible and
stiff. This can lead to problems
when rolling up!
Take care when the hose is mo-
Q
8 GB/IE/NI
ved it is not damaged by sharp
edges and objects.
Never store or put the hose in
Q
a place where there is direct
sunlight.
Never use the hose to carry
Q
dangerous liquids (chemicals,
acids, alkaline solutions, etc).
Turn off the air flow before
Q
rolling up the hose.
Always work cautiously and
Q
with the necessary care.
Never use excessive force.
Q
Operation

Hold the hose when unrolling and rolling up
so that the hose cannot injure anyone while
swinging about.
Pay attention to the maximum working pressure
of the hose. Only operate the hose within the
given parameters (see Technical data).
1. Plug the connection hose into the compressor.
2. Slowly unroll the desired length of hose.
3. Connect the compressed air tool by means of the
fast coupling.
Fig. 1 Connect compressed air hose
4. Remove the tool from the hose after the work has
been completed by pulling the coupling back-
wards hard. Roll up the hose again when the job
is done.