Publicité
SET UP:
- Download the Taurus Connect App form the
App Store or Google Play.
- Sign up using your email address and pass-
word.
- Confirm the registration using the verification
code that will be sent to your email account.
- Create your home, name it, establish the geo-
graphical location and select the room where
you are going to place this smart appliance.
- Add Top Temp Connect by following the steps
described in THE QUICK GUIDE.
IMPORTANT
- The device only supports 2.4GHz Wi-Fi net-
work.
- If the connection fails again, check the follo-
wing possible causes
- Top Temp Connect is too far away from the
router.
- The Wi-Fi password is incorrect.
- The Wi-Fi network is not 2.4GHz
COLD MODE:
- Press mode to select cold mode, the cold
mode indicator will light up.
- Press + or - to set the temperature in a range
of 16~31°C.
- Pressing + or - once, the temperature will
increase or decrease gradually.
- Press (E) to select high or low fan speed.
HEATING MODE:
- Press mode to select heating mode, the hea-
ting mode indicator will light up.
- Press + or - to set the temperature in a range
of 16~31°C.
- Pressing + or - once, the temperature will
increase or decrease gradually.
- Press (E) to select high or low fan speed.
FAN MODE:
- Press mode (D) to select the fan mode and the
fan indicator will light up. Press (E) Speed to
increase or decrease power speed.
DEHUMIDIFIER MODE:
- Press (D) to select the mode
- Dehumidification mode indicator, and the dehu-
midification mode indicator will light up.
TIMER FUNCTION:
SETTING THE TIMER ON:
- When the air conditioner is off, press the "F"
button and select the desired power-on time
through the temperature and time adjustment
buttons.
- The on time can be set up to 24 hours.
- The programmed time or remaining time will
appear in the display (G).
SETTING THE TIMER OFF:
- When the air conditioner is on, press the
"F" button and select the desired sleep time
through the temperature and time adjustment
buttons.
- The shut-off time can be set up to 24 hours.
- The programmed time or remaining time will
appear in the display (G).
COMPRESSOR PROTECTION:
- Three minutes after pressing on / restarting,
the compressor will start to operate.
PROTECTION OF THE WATER TANK:
- When the water level in the lower water plate
is below the warning level, the appliance will
notify you automatically.
- Please pour the water in the machine accor-
ding to the instructions in the chapter "water
drainage".
WATER DRAINAGE:
- This machine has two drainage methods: ma-
nual drainage and continuous drainage(fig 5).
- When the inside of the water tank is full, the
indicator will light up on the display.
- The device enters the standby mode.
- Remove the plug to remove the water, turn the
machine off and on again, the machine will
operate normally.
- This model has a self-evaporating function, in
the cold mode, please do not make continuous
drains to get a greater effect of cold.
Publicité
