SECTION 7 (CONTINUED) / SECTION 7 (SUITE) / SECCIÓN 7 (CONTINUACIÓN)
TOOLS AND PARTS REQUIRED / OUTILS ET PIÈCES REQUIS / INSTRUMENTAL Y HERRAJE REQUERIDOS
7.2
• Secure a wall support channel (AFM) to the corner wall panel (AGW) using four (4) screws (ADZ). The end with two holes goes at the bottom.
• Attachez un canal de support (AFM) au panneau mural (AGW) à l'aide de quatre (4) vis (ADZ). L'extrémité avec deux trous va vers le bas.
• Top End
• Extrémité
• Sujete un canal de soporte (AFM) al panel mural (AGW) usando cuatro (4) tornillos (ADZ). El extremo con dos agujeros va hacia abajo.
supérieure
• Extremo superior
• No screw in bottom hole.
• Aucune vis dans le trou inférieur.
• Ningún tornillo en el agujero inferior.
7.3
• Secure a wall support channel (AFM) to the corner wall panel (AGY) using four (4) screws (ADZ). The end with two holes goes at the bottom.
• Attachez un canal de support (AFM) au panneau mural (AGY) à l'aide de quatre (4) vis (ADZ). L'extrémité avec deux trous va vers le bas.
• Top End
• Sujete un canal de soporte (AFM) al panele mural (AGY) usando cuatro (4) tornillos (ADZ). El extremo con dos agujeros va hacia abajo.
• Extrémité supérieure
• Extremo superior
• No screw in bottom hole.
• Aucune vis dans le trou inférieur.
• Ningún tornillo en el agujero inferior.
ADZ (x8)
ADZ
ADZ
• Two holes at bottom end
• Deux trous à l'extrémité inférieure
• Dos agujeros al extremo inferior
AGY
• Two holes at bottom end
• Deux trous à l'extrémité inférieure
• Dos agujeros al extremo inferior
47
ADZ
ADZ
AFM
ADZ
ADZ
ADZ
AGW
AFM
ADZ