Publicité
seguenti operazioni:
1) Controllare le connessioni alla batteria.
2) Verificare che non sia staccata la spina di alimentazione o un filo
della stessa.
3) Verificare che non sia intervenuto il termostato.
SIGNIFICATO DELLE SCRITTE E DEI SIMBOLI
U
... V/Hz
Valori nominali della tensione d'alimentazione e della frequenza
1
U
... V
Valore nominale della tensione a vuoto
2
I
... A
Valore nominale della massima corrente assorbita
n
I
... A
Valore nominale della corrente di uscita in corrente continua
2
I
...A
Corrente di avviamento
2boost
Cr... Ah
Capacità nominale della più grande batteria che il caricabatterie può portare dal 20% al 80% in 15 h.
Cmin ... Ah
Capacità nominale della più piccola batteria che può essere utilizzata.
W
Simbolo per apparecchi senza controllo automatico di fine carica.
P.....KW
Potenza assorbita
Simbolo corrente continua
SAFETY RULES
For the operator's safety we recommend as follows and to read the
instructions carefully before using the unit:
1) Disconnect power supply before connecting or disconnecting the
connections from the battery.
2) During the charge, batteries can produce explosive gas. Avoid
sparks or flames – provide a proper ventilation during the
charge. Don't smoke.
3) To ensure protection against indirect contacts, connect the device
only to a socket having an earth connection .
4) Do not expose the unit to rain or snow.
5) Connecting clamps and battery terminals should always be kept
clean.
6) Absolutely avoid reverting polarities.
7) Among this charger-starter's components there are switches or
relays which can cause electric arcs or sparks; therefore, if the
device is used in a garage or similar places, place the starter-
charger in a safe area or in a package suitable to this purpose.
8) Do not recharge unrechargeble batteries.
9) Don't pull cables. Don't transport the charger raising it by the
cables.
10) the use of batterie charger it is forbidden to children and to
people not trained
This set cannot be used from people ( children included) with low
phisical or mental faculties . Children cannot play with this set.
11) do not connect or disconnect clamps of battery charger when it
is working.
12) please place battery charger in stable position when it is
working.
TECHNICAL FEATURES
The products of this series are devices suitable to charge and start a
lead-acid batteries with electrolytic liquid. They are all supplied by
an AC (alternating current) 1ph 230V - 50Hz current.
This charger is supplied with mains cable and positive (red) and
negative (black) charging clamps.
The charging current delivered by the battery decreases according
to the characteristic W bend - see the DIN 41774 norm.
CAR BATTERY CHARGE
Please connect clamps when power cable is disconnected.
Open tops of battery.
Battery is not installed :
1.
connect red clamp (+) to positive pole.
2.
Connect black clamp (-) to negative pole ( it is smaller of
positive pole)
3.
Connect the power cord to a 230 V outlet with earth
4.
when charge is made, disconnect first the power cord
Battery is installed:
Connect the black clamp (-) to the chassis of the car
keeping distance from fuel channels
Se questi controlli non risultano efficaci, contattare un tecnico
specializzato
MANUTENZIONE
Il caricabatterie non richiede manutenzione. Per pulizia ordinaria utilizzare
uno
straccio
GB - User Manual
Connect the red clamp (+) to the positive (+)
Connect the power cord to a 230 V outlet with earth
when charge is completed , disconnect for first power cord.
for second black clamp and for third red clamp.
Screw tops again
The length of charge can approximately be worked out by dividing
the capacity in amps per hour of the battery by the charge current I
For instance for a battery of 80Ah capacity and with I
have: 80/10 = 8 hours charging time. At the end of the charge, the
charge indicator will move gradually towards the minimum.
The charger has a thermostatic protection which switches itself on
when the temperature of the transformer's windings exceeds the set
maximum temperature, in
amperometer will go to minimum position indicating that the charge
is being interrupted. In order to restore the charge process, waiting
few minutestime for cooling and push the button on the front panel
with the "push to reset" written.
SIMULTANEOUS CHARGES OF SEVERAL BATTERIES
To charge more than one battery simultaneously, connect them in
series or in parallel. Among the two procedures, the connection in
series is preferable, as it allows the user to check that the current in
each battery corresponds to that indicated by the ammeter. (Set the
capacity to the lowest capacity of the two batteries and the charging
voltage to the sum of the battery voltages). To stop the charge,
disconnect as per the following sequence: the mains, the negative
terminal, the positive terminal.
In case of malfunction, carry out the following:
1) Ensure that the clamps are connected to the correct and
appropriates terminals;
2) See that the mains plug is properly connected and wired.
3) Check that the charger-starter's thermostatic protection has not
switched on. If problems persists, contact a qualified technician.
N.B.:
If the charger's mains cable becomes damaged, it must be
replaced exclusively by a qualified workshop as special tools are
required for this operation.
GENERAL INFORMATIONS ABOUT CHARGER - BOOSTERS
1) The charger starter is a device capable to deliver high current for
short period of time. Therefore, you must never insist too much on
the starting because these are risks to damage either the engine
starter either the charger - starter itself.
Every charger starter indicates always the maximum current which
is able to deliver; by consequence when you choose a charger
starter you must verify that the maximum starting current
corresponds to the starting current of the battery.
For example if the battery fitted into the vehicle is an 88Ah battery,
its starting current (if it is not already indicated) is included in a
range between 3 and 3,5 times its nominal capacity, it means
between 260A and 310 Ampere.
To help start a vehicle it is necessary to have a charger starter
capable to deliver similar current values.
umido
con
alimentazione
such case,
the pointer
scollegata.
.
2
= 10A. We
2
of the
Publicité
