Publicité
Troubleshooting
Problem
The steam from the iron
is too wet.
Water is coming out from
the boiler.
There is no steam coming
out of the iron, nozzle
or gun.
The steam is dirty.
Machine shuts of
automatically
16
Possible Causes
1. While filling the tank you
may have poured too much
water into it.
2. The iron soleplate is not
getting hot enough.
There might be a leak in the
heating element gasket.
1. The steam knob might
be closed
2. The iron switch might be off
3. The foot pedal is not
plugged in (7000CJ)
4. The boiler switch might
be off
5. If the low water light is on,
the water in the tank is low
or empty.
When using the iron with a
ironing shoe, if not cleaned
regularly, calcium will form
between the shoe and the iron
base.
Machine is low on water.
Remedy
1. The problem will go on until the
excess water is emptied. Keep the
steam button pressed until the
water in the tank is at the correct
level.
2. Please check that the temperature
knob is on the right position, if not,
increase the iron temperature.
Contact technical support as in most
cases, the gasket will need to be
replaced.
1. Open the steam knob
counterclockwise.
2. After the iron switch comes on,
wait for 4 minutes so that the iron
plate gets hot.
3. Plug the 4-pin receptacle into the
boiler.
4. After the boiler switch comes on,
wait for 10 minutes so the boiler
produces steam.
5. Refill the boiler carefully following
the instructions.
Remove and rinse the ironing shoe
on a regular (monthly) basis to avoid
scale build-up.
1. Press the steam iron button
or foot pedal to ensure
there is no more steam
in the boiler.
2. Slowly open the pressure
cap (1) and refill to
the required level with
warm water.
3. Tighten the cap, unscrew
thermostat reset button (14, 11 or
13) and press it, wait for it to build up
pressure again. Note: The low water
light will turn off when you hit the reset
button.
Publicité
