Device Settings - IBP TD 4222 Mode D'emploi

12 device settings

When your measuring device is delivered, the time, date, measuring units and temperature units are preset.
If you want to change the settings, to replace the battery or to delete the memory contents, you must
switch to setting mode before carrying out changes.
how to set the time and date
1. Setting the year:
Leave the device switched off. Remove the battery compartment
cover on the bottom of the device, and press the Setting button
(SET) in the battery compartment. The display will show the year
flashing (Fig. 25). Press the Menu button to change the year. Once
the required year is shown in the display, press the Setting button
(SET) in the battery compartment to confirm the setting and to
switch to the month.
2. Setting the month:
The month is flashing (Fig. 26). Press the Menu button to set the
month. Press the Setting button (SET) to confirm the setting and
to switch to the day.
3. Setting the days, hours and minutes:
Proceed in a similar manner to set the day, and minute, and to
switch to setting the measurement unit (mmol/L or mg/dL).
24
( Fig. 25)
( Fig. 26)