Publicité
Using Control Panel 1
8. Water Care
Ozone unit will automatically start when system is powered on.
9. Children lock protection setting
When the system is powered on, press constantly "
Then press "
" to set the children lock function. When the setting is done, the system will save it.
Children lock protector disabled
Children lock protector enabled
If no button is touched within 3 minutes, then all the buttons will be locked, and no operation can be
done. At the same time, the LCD displays "LOC"; press and hold any button for 3 seconds to unlock
the panel. All the buttons work and "LOC" disappears from the screen.
10. Light
When the control system is powered on and operates neither in sleeping mode nor setting mode,
press the key "
" to control light. Press the key "
Light has two modes. In on / off mode, light turning on and off are controlled. In RGB mode,the
control regulation is as below:
• state 1 auto color change (color changing among state 2 to state 8 in cycle)
• state 2 red
• state 3 green
• state 4 yellow
• state 5 blue
• state 6 purple
• state 7 cyan
• state 8 white
• state 9 turning off
9
" until it goes to children lock setting interface.
" for 2 seconds to turn off the underwater light.
Using Control Panel 2
Panel Function Diagram
IMPORTANT: If your control panel is different than the one picture here, go back to page 6
1.
Power
When the control system is powered on, press "
" for one second to turn on
or off the system.
2.
Temp Unit
When the control system is turned on, press " " and "
" at the same time to change the
temp unit (°C or °F). The system will store the setting.
3.
Temp adjustment
When the control system is turned on, press "
" to increase the setting temp and press " " to
decrease the setting temp.
Setting temp range: 3-40°C (37-104°F)
4.
Light
4.1 When the control system is turned on, press " " to control the light. Press and hold "
seconds to turn off the light directly.
4.2 Within 5 minutes after the system is powered on and not in setting operation, press and hold "
8 seconds to change the working mode of the light. (on/off mode and RGB mode) (this function is only
valid for configuring in factory.)
4.3 In on/off mode, only on and off options for the light can be controlled.
4.4 In RGB mode, the working pattern is as follows：
State 1: automatic color change (cycle through state 2-8)
State 2 : red
State 3 : green
State 4 : yellow (green+red)
State 5 : blue
State 6 : purple (blue+red)
State 7 : cyan (blue+green)
State 8 : white
" for 2
" for
10
Publicité
