Publicité
The built-in microcomputer remembers the position once it is set. The product repeats the
same setting by touching the power button. If it is disconnected by unplugging the power
cord or if the power goes out, you have to start setting again.
3.4 Water tank
If the water reservoir is full or not correctly placed, the product will not work. You must take
out the water reservoir, empty it and put it back correctly before the product will work again.
1
1.
Hold the water tank with two hands. Gently pull out the water tank as shown in image 1.
2. Hold the water tank by the handle and carefully empty the water tank as shown in image
2.
3. Replace the water tank as shown in image 3. The product will automatically start working
again.
3.5 Sound signal
When the water tank is full of water, the product will stop working and emit an audible signal.
The audible signal will be audible for 20 seconds after you remove the water tank from the
product.
3.6 How to use
1.
Make sure the water tank is empty and properly placed.
2. Plug the power cord into the power outlet.
3. Touch the power button to turn on the product.
4. Select the desired mode by touching the mode button (repeatedly).
5. Touch the on/off button to turn the product off.
34
2
3
Publicité
