Publicité
Winterizing + Long-Term Storage
If you must store your pressure washer in a location where
the temperature falls below 32ºF (0ºC), you can minimize the
chance of damage to your machine by utilizing the following
procedure:
• Disconnect all water connections.
• Turn on the machine for a few seconds until the remaining
water in the pump exits. Turn off immediately.
• Do not allow the high-pressure hose to become kinked.
• Store the machine and accessories in a room that does not
reach freezing temperatures.
• Do not store near a furnace or other sources of heat that
may dry out the pump seals.
• Operate the pressure washer with non-corrosive/non-toxic
anti-freeze, a pump saver, or a pump protector before
storing for the winter.
m
WARNING!
Before reusing, completely flush the unit
out with clear water. Anti-freeze products can damage paintwork,
so you must ensure there is no anti-freeze left in the system
before using it again.
Maintenance
m
CAUTION!
Before working on the pressure washer,
disconnect the plug from the power supply socket.
1. To ensure good performance, check and clean the adapter
filter (Fig. 27). Remove the filter and rinse with warm water
to prevent any foreign matter from clogging the pump
(Fig. 28).
Fig. 27
Adapter filter
Garden hose adapter
Fig. 28
2. Clean the nozzle with the needle clean-out tool provided
(Fig. 29). Remove the spray wand from the gun; remove any
dirt from the nozzle hole and rinse.
Fig. 29
3. Remove additional debris by back flushing water through
the nozzle and spray wand. To do this, place the end of
your garden hose (with water running) to the tip of the
nozzle, pushing water and debris out of the back opening of
the nozzle and spray wand.
15
Filter
Needle clean-out tool
Publicité
