Publicité
m
WARNING!
Keep hose away from sharp objects. Bursting
hoses may cause injury. Examine hoses regularly and replace if
damaged. Do not attempt to mend a damaged hose.
12. Thread your garden hose (male end) into the garden hose
adapter (Fig. 16). The garden hose must have an internal
diameter of at least 13 mm (1/2 in.) and must be reinforced.
The water supply must be at least equal to the washer
delivery capacity.
NOTE: The machine is not suitable for connection to the
potable water main. If connection is made to a potable water
system, the system shall be protected against backflow.
Fig. 16
Water inlet
(female coupler)
Garden hose
13. Attach garden hose to water supply (Fig. 17).
Fig. 17
Connect to water supply
Garden hose
m
WARNING!
The intake water temperature must not exceed
104ºF/40ºC. The water supply must not exceed
0.7 MPa.
m
CAUTION!
The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals will
damage the washer.
14. Make sure the motor switch is pushed to the OFF (0)
position before plugging the unit into the power outlet
(Fig. 18).
Fig. 18
15. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the pressure
washer rating plate. If the power supply is correct, you may
now plug the pressure washer into the power outlet (Fig.
19).
Fig. 19
GFCI
Power light
indicator
NOTE: The GFCI may need to be reset when first plugged
into the electric outlet. Press the "Reset" button until the
power light indicator on the GFCI illuminates.
Operation
m
IMPORTANT!
This pressure washer is equipped with
a micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating, thus saving energy and prolonging pump life.
1. Turn the water supply tap on completely.
2. Make sure the safety lock is down and in its original
position (Fig. 20), then press the trigger for a few seconds
until water flow is steady. This will allow air to escape and
discharge any residual pressure in the hose.
11
OFF
ON
Reset
Publicité
