Publicité
EN
The installation of the device and maintenance should only be carried out by professionals.
• Do not leave the device running without monitoring it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
MANUAL
FACILITY
Installation, adjustment and adaptation to other types of gas as well as commissioning can only be carried
out by an instructed person, authorized for this type of operation and only in accordance with the standards in
force. The appliance must be placed in a well-ventilated space to ensure the draft of combustion gases. The
device needs 2 m3 of air over 1 hour and 1kW of power.
The device can be installed alone or in series with other devices of our manufacture. It is necessary to
respect the
minimum distance of 10 cm between the device and other objects as well as avoid contact with flammable
materials. In this case, make the necessary arrangements to ensure protection of flammable parts.
Safety distances for flammable materials according to their degree of flammability:
-A non-flammable: granite, sandstone, concrete, bricks, ceramic tiles, coating
-B hardly flammable: acumin, heraclitus, lihnos, itaver
-C1 poorly flammable: wood from hardwood trees, plywood, hardened paper, umakart
-C2 medium flammability: chipboard, solodur, cork, rubber, coverings
-C3 easy flammability: wood fiber boards, polystyrene, polyurethene, PVC
Place the device upright on a solid, flat surface. This is equipped with adjustable feet.
FR
• EN 06 1008 fire protection for local energy consumers and heat emitters
• EN 33 2000 (33 2000-4-482; 33 2000-4-42) the environment for electrical appliances
GAS INLET PIPE
Determine whether the appliance is suitable for the type of gas used so that it complies with the instructions
on the label.
To convert to another gas type, check the match to the gas bearing type.
Connection of the appliance to the gas distribution must be made to a steel or copper tube complying with
applicable national requirements. Equipment should be checked on a regular basis: change if necessary.
The flexible connection between the plate and the gas installation of the premises must be approved
according to the standards in force. A valve or cut-off cock must be located upstream of the connection hose
to isolate the plate from the gas inlet.
After installation, check for possible leaks (use a suitable and approved leak detector).
The device has been tested by the manufacturer, the technical data of the device is stated on the label.
Check the type of gas the appliance is set for
Check if the appliance is set for the type of gas you are using. The type of gas is indicated on the label of
each appliance.
Process of rebuilding the device for another type of gas
The device is adjusted and controlled for liquefied gas (see label). Reconstruction for another type of gas
must be carried out by a qualified person. The nozzles are included in the package with the instructions for
use.
Replacing the main burner nozzle: photo D
Remove the upper parts of the burner (A), unscrew the nozzle (D) and screw in the new nozzle for the type of
gas required - see the technical table - without adjusting the air supply.
It is not necessary to adjust the air supply:
After changing the gas type, change the data on the label.
How to check the operation of the device:
- check for gas leaks
- check the ignition and the flame of the main burner
Publicité
