Publicité
5 Exterior Graphic Placement
While using the handling tabs align the Exterior Graphic into
position.This allows the part to float on the surface until proper
fit is achieved.
Squeegee Exterior Graphic
7
Use caution not to scratch the paint surface with the squeegee.
Using smooth even overlapping strokes squeegee the Exterior
Graphic into position.
*
(Repeat Steps 1-9 for the opposite side of vehicle.)
9
Inspect Exterior Graphic
If bubbles are present after premask carrier removal, wrap a towel around the
squeegee and carefully attempt to push the bubble to the side of the Exterior
Graphic. If the bubble cannot be moved, use a sewing needle to pierce the
bubble and press the remaining solution from beneath the Exterior Graphic.
DESCRIPTION
Exterior Graphics - Side Rear Window
6
8
ISSUE
DATE
00
9/30/21
Spray Exterior Graphic Premask
Spray the top surface of the premask with the soap and water
solution. This makes it possible for the squeegee to slide easily
across the surface.
Premask
Exterior Graphic
Remove Premask
Carefully remove the premask from the Exterior Graphic by slowly
lifting and pulling backward at an 180º angle as shown.
SUBARU OF AMERICA
PAGE
3 / 4
Publicité
