Publicité
GB
vice agent of the same or a similarly
qualified person in order to prevent
hazards. The line must be minimum
10 m long.
•
Do not pull the plug from the socket
by the cable. Protect the cable from
heat, oil and sharp edges.
•
Do not carry or fix the equipment by
the cable.
•
Use only extension cables that are
protected from spray water and de-
signed for outdoor use. Always fully
unroll a cable drum before use. Check
the cable for damage. The flexible
lead cross-section of the extension
cord must at least 2.5 mm
•
Disconnect the mains plug from the
socket before all work on the equip-
ment, in case of leaks in the water
system, during work breaks, and
when not in use.
Initial Operation
Positioning/Hanging
•
The dimensions of the pump shaft
must be not less than 40 x 40 x 50
cm, in order that the float switch
(
7) can move freely.
•
The pump can be suspended by the
round handle (
shaft floor.
The pump can be suspended and/or
removed using the nylon cord (
provided.
Never suspend the pump by the
hose.
Ensure that the equipment is not
hung up or held by the mains
cable. There is a risk of electric
shock from damaged mains ca-
bles.
48
All manuals and user guides at all-guides.com
.
2
1) or placed on the
11)
Note that, over time, dirt and sand
may collect on the bottom of the
shaft, which could damage the
pump.
We recommend standing the pump
on a brick.
If the water level is too low, the silt in
the shaft can quickly dry out and im-
pede the pump when warming up.
Mains Connection
The pump you have purchases is already
fitted with an earthed plug. The equipment
is designed for connection to an earthed
wall socket with a residual current operat-
ed device (RCD switch) at 230 V ~ 50Hz.
Connecting the Pressure Line
The pump is installed
-
Either with a fixed pipeline
-
Or with a flexible hose line.
1. Screw the bracket adapter (10)
onto the pump outlet (3).
2. Fit the hose over the reducer (9)
and secure it with a hose clamp.
Or use a screw connection at
the bracket adapter (10) or the
reducer (9).
Œ
Outlet with a 1½" internal thread on
the pump for connection of the angle
adapter (10) or for direct connection of
a hose with a 1½" external thread;
Outlet with 1½" external thread at the
bracket adapter (10) for connection of
the reducer (9) or a 1½" screw con-
nection;
Outlet on reducer (9) for connection of
Ž
a 1¼" or 1½" hose as a compression
joint (fixing with a hose clamp);
Publicité
