Publicité
Disposal of Old Equipment and Batteries
Only for European Union and countries with recycling systems
These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries
must not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points in accordance
with your national legislation.
By disposing of them correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the
environment.
For more information about collection and recycling, please contact your local authority.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
Note for the battery symbol (bottom symbol):
This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the
chemical involved.
For Europe
For CE marking, refer to the followings:
Declaration of Conformity (DoC)
"Hereby, Panasonic declares that this computer is in compliance with the essential requirements and other relevant provisions of the Directive 2014/53/EU."
If you want to get a copy of the original DoC of our above mentioned products, please contact our web address: https://www.ptc.panasonic.eu
Panasonic Connect Co., Ltd.
4-1-62 Minoshima, Hakata-ku, Fukuoka 812-8531, Japan
Authorised Representative in EU:
Panasonic Testing Centre
Panasonic Connect Europe GmbH
Winsbergring 15, 22525 Hamburg, Germany
Maximum radio - frequency power transmitted in frequency bands
Type of wireless
WLAN
Bluetooth
HF-RFID (Contactless Smart Card Reader)
Information about the Energy Efficiency of the AC Adaptor
Please visit our website, www.panasonic.com, and enter the model number on the AC adaptor (11 or 12 characters, including dash "-", excluding space) in the
search box.
<Only for model with external antenna>
When using Port Replicator or Car Mounter on which an external antenna can be installed:
Ÿ External antenna for wireless LAN must be professionally installed.
Ÿ The gain of external antenna for wireless LAN must not exceed 5 dBi.
Ÿ The user must maintain minimum of 20 cm spacing between the external antenna and all people (excluding extremities of hands, wrist and feet) during wire-
less modes of operation.
AC cord with BS 1363 plug
<For model that has a AC cord with BS 1363 plug>
For your safety, please read the following text carefully.
This appliance is supplied with a molded three pin mains plug for your safety and convenience.
A 3 ampere fuse is fitted in this plug.
Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 3 ampere and that it is approved by ASTA or BSI to BS1362.
Check for the ASTA mark
or the BSI mark
A S A
If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced.
If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local dealer.
If the fitted molded plug is unsuitable for the socket outlet in your home then the fuse should be removed and the plug cut off and disposed of safely.
There is a danger of severe electrical shock if the cut off plug is inserted into any 13-ampere socket.
How to replace the fuse
The location of the fuse differs according to the type of AC mains plug (figures A and B).
Confirm the AC mains plug fitted and follow the instructions below. Illustrations may differ from actual AC mains plug.
Open the fuse cover with a screwdriver and replace the fuse and close or attach the fuse cover.
Figure A
Figure B
2412 - 2472 MHz
5150 - 5250 MHz (W52)
5250 - 5350 MHz (W53)
5470 - 5725 MHz (W56)
5925 - 6425 MHz
2402 - 2480 MHz
13.56 MHz
on the body of the fuse.
Fuse cover
Frequency band
17.0 dBm
18.0 dBm
18.0 dBm
18.0 dBm
18.0 dBm
11.0 dBm
42 dBuA/m at 10 m
36-E-1
18-E-1
Maximum transmit power
41-E-1
8-E-1
9
Publicité
