Mitsubishi Electric PAR-CT01MAA-S Manuel D'installation page 26

2 When the search is completed, the smallest address of the indoor units
that are connected to the remote controller and the address of the
interlocked LOSSNAY unit will appear. "--" will appear if no LOSSNAY
unit is interlocked with the indoor units.
If no settings need to be made, press the RETURN button to go back to
the Settings menu.
To make LOSSNAY interlock setting
3 Enter the addresses of the indoor unit and the
LOSSNAY unit to be interlocked, with the F1
through F4 buttons, select "Set" in the
"Function", and press the SELECT button to
save the settings. "Sending data" will appear
on the screen. If the setting is successfully
completed, "Setting completed" will appear.
To search for the LOSSNAY address
4 Enter the address of the indoor unit to which
the remote controller is connected, select
"Conf" in the "Function", and press the
SELECT button. "Collecting data" will appear
on the screen. If the signal is received
correctly, the indoor unit address and
LOSSNAY address will appear. "--" will
appear when no LOSSNAY unit is found.
"Unit not exist" will appear if no indoor units
that are correspond to the entered address
are found.
To delete the interlock setting
5 To delete the interlocked setting between
LOSSNAY unit and the indoor units to which
the remote controller is connected, enter the
indoor unit address and LOSSNAY address
with the F1 through F4 buttons, select "Del."
in the "Function", and press the SELECT
button. "Deleting" will appear. The screen will
return to the search result screen if the
deletion is successfully completed. "Unit not
exist" will appear if no indoor units that are
correspond to the entered address are found.
If deletion fails, "Request rejected" will
appear on the screen.
– 26 –