Mitsubishi Electric PAR-CT01MAA-S Manuel D'installation page 12

5 Install the bottom case.
Be sure to secure two places of the bottom case.
■ Installation using a switch box
Single switch box
Roundhead
cross slot
screws
Important
To avoid deformation and damage to the
bottom case, do not overtighten the screws.
6 Cut out the cable access hole.
■ Direct wall installation (when running the cable along the wall)
• Cut out the thin-wall part on the cover (the shaded area in the right
figure) with a nipper.
• Thread the cable from the groove behind the bottom case through
this access hole.
Notice
To prevent damage to the circuit board,
remove the front cover from the top case
before cutting out a cable access hole.
7 Connect the connector to the top case.
Connect the connector on the bottom case to the socket on the top case.
Connect the connector.
Important
To prevent malfunctions, do not remove the
protective sheet or the circuit board from the
top case.
Seal the cable
access hole
Wood
with putty.
screws
Refer to 2.
Remote
controller
cable
Refer to 4.
To avoid damage to the bottom case, do not
make holes on it.
Note that accidentally touching the circuit
board may damage the circuit board when
cutting out a cable access hole.
To prevent cable breakage and
malfunctions, do not hang the top controller
casing hang by the cable as shown in the
figure above.
– 12 –
■ Direct wall installation
Remote
controller cable
Refer to 4.