Mitsubishi Electric PAR-CT01MAA-S Manuel D'installation page 20

[2] Temperature unit setting
[Button operation]
Move the cursor to "Temperature" from the display details setting screen,
and select the desired temperature unit with the F3 or F4 button. (The
factory setting is Centigrade (ºC).)
• ºC: Temperature is displayed in Centigrade. Temperature is displayed
in 0.5- or 1-degree increments, depending on the model of indoor
units.
• ºF: Temperature is displayed in Fahrenheit.
• 1 ºC: Temperature is displayed in Centigrade in 1-degree increments.
[3] Room temperature display
[Button operation]
Move the cursor to "Room temp." on the display details setting screen, and select the desired
setting with the F3 or F4 button.
(The factory setting is "Yes".)
• Yes: Room temperature appears on the Main display.
• No: Room temperature does not appear on the Main display.
Note: Even when "Yes" is set, the room temperature is not displayed on the Main display in the "Basic" mode.
[4] Auto (single set point) mode display setting
[Button operation]
Move the cursor to "Auto mode" from the display details setting screen, and select the desired
mode with the F3 or F4 button. (The factory setting is "Yes.")
• Yes: "Auto Cool" or "Auto Heat" is displayed during operation in the Auto (single set point) mode.
• No: Only "Auto" is displayed during operation in the Auto (single set point) mode.
[5] Backlight
The backlight lighting-up time can be set.
[Button operation]
Move the cursor to "Backlight" from the display details setting screen, and select the desired time
(5/10/20/30/60 seconds) with the F4 button. (The factory setting is "30" seconds.)
Note: This setting is effective on the Status display and the Main display.
[6] LED lighting
The LED lighting can be set to either "Yes" (On) or "No" (Off). (The
factory setting is "Yes".)
When "No" is selected, the LED will not light up even during the normal
operation.
– 20 –