Publicité
Les langues disponibles
Les langues disponibles
Hole for control knob
The built-in control console can be integrated into the
lower cabinet at drawer level. Panel thickness:
(16 - 26 mm)
1
If front panel thickness is greater than 1" (26 mm):
Mill out front panel on rear side to the dimensions
3
/
" x 12
/
" (80 x 310 mm) to the point that the
1
3
8
16
thickness doesn't exceed 1" (26 mm).
For flush mounting:
8
2
According to the figure, create the drill hole Ø 1
(35 mm) for fixing in place the control knob in the
front side of the lower cabinet. A drilling template is
/
" - 1"
5
included for precise positioning of the drill hole.
8
For flush mounting:
/
"
3
8
Publicité
