RIDGID RT12000 Mode D'emploi page 8

ASSEMBLY
Locking Accessories
1. To Connect
RIDGID Wet/Dry Vac includes Locking
Accessories to prevent the Accessories
from falling off when in use. To
connect the Accessories, align the
Nozzle Ridges of the Accessory with
the Release Button of your Extension
Wand. Press to secure the Nozzle to
the Extension Wand.
CONNECT:
Accessory Nozzle
Ridges
2. To Disconnect Accessory: Twist
the Nozzle and Extension Wand to
disengage the Nozzle Ridges and pull.
You may also press the Release Button
and pull to disengage.
DISCONNECT:
SP7054 RT12000.indb 8
Accessory:
Your
Extension Wand
Release Button
Extension Wand
Release Button
Accessory Nozzle
Ridges
Inserting the Professional
Locking Hose
1. Locate the end of the Professional
Locking Hose and align it with the Drum
Inlet. Align the Hose Release Button with
the Ridges on the Vac Inlet. Push the
Hose end straight into the Vac Inlet until
the Hose Release Button fully engages
the Inlet Ridges.
2. To remove Hose, rotate the end of the
Professional
either direction
Hose Latch from the Inlet Ridges.
Press the Hose Release Button and
pull the Hose end straight out of the
Vac Inlet.
Hose
Release Button
Professional
Locking Hose
8
Locking Hose in
to release the
Drum
Vac Inlet
Ridges
9/5/18 12:04 PM