Troy Lee Designs Flowline FL Manuel Du Propriétaire page 7

10
CHECK THE FIT: BEFORE USING THE HELMET, MAKE SURE THAT IT FITS CORRECTLY, IT IS POSITIONED TO COVER YOUR ENTIRE
FOREHEAD, THE STRAPS ARE CORRECTLY ADJUSTED, AND THE CHIN STRAP IS TIGHT. GRAB THE HELMET WITH BOTH HANDS
AND TWIST IT TO THE LEFT AND RIGHT. IF THE HELMET FITS CORRECTLY, THE SKIN ON YOUR FOREHEAD WILL MOVE AS THE
HELMET MOVES. IF THE SKIN ON YOUR FOREHEAD DOES NOT MOVE, THE HELMET IS TOO LOOSE.
CHECK THE STRAPS: WITH THE HELMET ON AND THE CHIN STRAP BUCKLED, GRAB THE HELMET WITH BOTH HANDS AND
TRY TO REMOVE IT BY ROLLING THE HELMET FORWARD AND BACKWARD AS FAR AS YOU CAN. MAKE A SERIOUS EFFORT. IF
YOU CAN ROLL/PUSH THE HELMET OFF THE HEAD COMPLETELY IN EITHER DIRECTION OR ROLL IT FORWARD SO FAR THAT
IT BLOCKS VISION OR BACKWARDS SO FAR THAT IT EXPOSES THE FOREHEAD, YOUR HELMET DOES NOT FIT CORRECTLY.
REPEAT STEPS ABOVE UNTIL HELMET MOVEMENT IS MINIMAL.
TEST RIDE: ONCE YOU ARE SATISFIED THAT THE HELMET FITS CORRECTLY AND THAT ALL STRAPS ARE PROPERLY
ADJUSTED, TIGHTENED, AND SECURED, TAKE A SHORT BICYCLE RIDE IN A AREA FREE FROM TRAFFIC AND OTHER
HAZARDS. PAY ATTENTION TO OVERALL COMFORT AND STABILITY WHILE RIDING. MAKE MINOR ADJUSTMENTS
TO THE FIT PADS AND STRAPS TO IMPROVE COMFORT AND STABILITY. DO NOT MAKE ANY ADJUSTMENTS TO THE
HELMET WHILE RIDING AS THIS COULD CAUSE YOU TO LOOSE CONTROL OF THE BIKE OR CAUSE THE HELMET
TO FALL OFF AND BECOME DAMAGED OR ENTANGLED IN YOUR WHEELS CAUSING A CRASH.
10. HEIGHT BY LIGHTLY PUSHING UP OR DOWN UNTIL
THE VISOR CLICKS INTO ON OF THE THREE (3) POSITIONS
AS SHOWN IN FIG.10. (FOR FLOWLINE MODELS ONLY)
EN