EN
7
9
FLOWLINE SE
7. TWIST STABILIZER WHEEL (AT REAR OF HELMET)
CLOCKWISE TO TIGHTEN AGAINST THE BACK OF THE HEAD.
FLOWLINE
TIGHTEN UNTIL HELMET FITS SNUG AND SECURELY. TWIST
STABILIZER WHEEL COUNTER-CLOCKWISE TO LOOSEN
TENSION AGAINST BACK OF HEAD TO REMOVE HELMET.
8. ADJUST STABILIZERS REACH ON BACK OF HEAD BY
GENTLY PULLING OUT END OF ARM PROTRUDING INTO
HELMET SHELL. LOCATE THE END OF THE STABILIZER BALL
MOUNT IN ONE OF THE THREE HOLES FOR DESIRED FIT.
PUSH TO CLICK FOR SECURE MOUNTING.
9. INSTALL LINER USING SPECIFICALLY LOCATED VELCRO
MOUNTING POINTS. LINER WILL STICK TO VELCRO AND
HOLD LINER INTO POSITION. INSERT LINER INTO SHELL
BY STARTING AT THE FRONT OF THE FOREHEAD, SECURING
THE LINER TO VELCRO MOUNTS AS YOU WORK TO THE
BACK OF THE HELMET.
8