Bigben PARTYBTIPFLY Mode D'emploi page 16

Use
Charging Your BT speaker with light effect
1. Your BT Speaker has a built-in rechargeable battery. Before using it for the first time,
please fully charge the battery.
2. To charge, connect the USB cable provided to the USB-C port on your BT speaker.
3. Connect the other end of your USB cable to a USB port on your computer or a 5V 1A USB
wall charger (Not included).
4. When connected successfully, the indicator light turns on Red. When charging is
complete, the indicator light turns off.
Notes:
When entering the low battery state, the volume is automatically reduced to 50 %.
After the low battery alarm rings, please recharge the battery.
Pairing with a Bluetooth Device
1. Long press the On / Off button to turn on the speaker until you hear a short tone. It will
enter Bluetooth mode automatically.
2. Enable Bluetooth on your Smartphone or Bluetooth device and search for Bluetooth
connections. Select 'PARTYBTIPFLY' from the list of found devices. When successfully
paired, you will hear a brief tone.
3. When the device's Bluetooth is activated and in range, you do not need to re-pair any
previously connected devices.
4. The BT speaker will attempt to automatically connect to the last device it was paired with
if it is turned on. If you want to pair it with a new device, turn off your last paired Bluetooth
device or disable Bluetooth on it, and then use your new device to search and select the
pairing.
Notes:
- Product will automatically power Off after 30 minutes if no audio is detected.
- Product will automatically power Off after 5 minutes if no Bluetooth device was connected.
Playing your music
When your smartphone or tablet is paired to the speaker, use your music app to playback
your music.
RGB lighting
The blue LED light fades slowly: the device switches on.
LED RGB lighting: once you are in Bluetooth/TF card/Aux-in mode, short press the light button
to choose from the 11 lighting modes (or stop the lighting effects).
LED lighting off: press twice to switch the light off.
Using Aux-in
Once the speaker is switched on, insert the Aux-in cable (not included) into the Aux-in port.
The speaker switches to Aux-in mode and starts playing music. The Bluetooth mode will be
disconnected.
- EN 16 -