Kenwood KDC-MP238 Mode D'emploi page 4

Basic Operation
Release
[VOL]
General functions
Power/Source Select button
Turns on the power.
When the power is on, the source switches between
Tuner ("TUNER"/ "TUnE") , CD ("CD") , Auxiliary input
("AUX"/ "AUH"), and Standby ("STANDBY"/ "STBy") each
time this button is pressed.
Press at least 1 second to turn off the power.
⁄
• When an optional accessory is connected, the source name
for each device appears (KDC-MP238 only).
Volume control [VOL]
Bass boost [B.BOOST]
Switches between Boost 1 ("BB-L L1"/ "L1 BB-L"), Boost
2 ("BB-L L2"/ "L2 BB-L"), and Boost off ("BB-L OFF"/ "OFF
BB-L") each time this button is pressed.
Faceplate release Release
Releases the faceplate lock so that it can be removed.
Refer to the following diagram when reattaching the
faceplate.
¤
• The faceplate is a precision piece of equipment and can be
damaged by shocks or jolts.
• Keep the faceplate in its faceplate case while detached.
(KDC-MP238/KDC-238CR/KDC-138CR)
• Do not place the faceplate (and the faceplate case) in areas
4
|
KDC-MP238/CR/KDC-MP208/KDC-138/CR
All manuals and user guides at all-guides.com
Display Disc slot
[SRC] [1] [2] [3] [4] [5] [6] [AUTO] [B.BOOST]
[SRC]
Control [ ]
knob
exposed to direct sunlight, excessive heat or humidity. Also
avoid places with too much dust or the possibility of water
splashing.
• To prevent deterioration, do not touch the terminals of the
unit or faceplate with your fingers.
Auxiliary input Auxiliary input
Connect a portable audio device with mini-plug cable
(3.5 ø).
⁄
• Use the mini-plug cable which is stereo type and does not
have any resistance.
Muting volume upon reception of phone call
When there is a call, "CALL" is displayed and the audio
system is paused.
When the call ends, "CALL" disappears and the audio
system comes back on.
The audio system comes back on when [SRC] is
pressed during a call.
Subwoofer output (KDC-MP238/KDC-MP238CR/
KDC-MP208/KDC-138)
Switches between ON ("SW ON"/ "On SUB") and OFF
("SW OFF"/ "OFF SUB") each time the bottom side is
pressed for at least 2 seconds.
Clock display (KDC-138/KDC-138CR)
Control knob
Switches between ON and OFF each time the center
is pressed at least one second.
Auxiliary input
Control knob