Setting Down, Transportation And Storage - Miele Complete C3 Electro EcoLine Mode D'emploi

en
To switch on and off (dia. 20)
 Press the On/Off foot control .
To regulate the suction power
(dia. 21)
The suction power can be regulated to
suit the type of flooring being cleaned.
Reducing the suction power reduces
the amount of effort required to ma‐
noeuvre the floorhead.
The vacuum cleaner has symbols on
the controls which indicate the type of
use the settings are suitable for.
 Curtains, fabric
 Upholstery, cushions
 Deep pile carpets, rugs and run‐
ners
 Energy-saving vacuuming. This
setting is also very quiet
 Loop pile carpet and rugs
 Hard flooring and heavily soild
carpets and rugs
When using the Electrobrush / floor‐
head, if the suction seems too high,
reduce the suction until the Electro‐
brush / floorhead is easier to manoeu‐
vre.
The first time the vacuum cleaner is
switched on, the highest setting will be
selected automatically.
After that the vacuum cleaner will
switch on at the setting which was used
previously.
 Press the + foot control to select a
higher setting.
38
 Press the - foot control to select a lo‐
wer setting.
During vacuuming
 When vacuuming, pull the cleaner
behind you on its wheels. You can
stand it upright for vacuuming stairs
and curtains etc.

When vacuuming fine dust, e.g.
sawdust, sand, plaster, flour, talcum
powder etc., electrostatic charges
build up naturally. Under certain con‐
ditions these charges will be re‐
leased. To avoid the unpleasant ef‐
fects of these discharges, a metal in‐
lay has been incorporated into the
upper arched part of the handle.
Please make sure that you keep your
hand in constant contact with this
metal strip during vacuuming. (dia.
22)
Setting down, transportation
and storage
Park system for pauses during vac‐
uuming (dia. 23)
(cannot be used with the Electrobrush)
The Park system allows you to conven‐
iently park the suction tube and floor‐
head during pauses.
 Slot the floorhead into the parking at‐
tachment at the back of the vacuum
cleaner.
If your vacuum cleaner is on a slop‐
ing surface, e.g. a ramp, retract the
telescopic tube fully.