Leckey Leeway Pelvic Cradle Mode D'emploi page 7

8.1 Preparing for
the client
When setting up the Leeway for the first time
the Leeway should be flat with the Velcro side
tabs open. All four side and back buckles
should already be attached to the seat.
8.2 Positioning the client
in the Leeway
Position the client into the seat and establish
the correct posture with the front strap
of the Leeway positioned at the inguinal
crease. As a check, if the Leeway is too far
forward it will be too low on the user's back,
conversely if it is too far back it will be too
high up the user's back.
8.3 Securing the client
in the Leeway
There are two buckle options, the standard
side release (a) and the security buckle (b)
that has a secure three point release requiring
two fingers and a thumb to open. Fasten your
chosen buckle at the front of the Leeway.
Adjust the tension using the D-rings to
provide a snug fit. If it is difficult to secure this
buckle, check that the user is positioned well
back in the seat/Leeway. Re-positioning or an
alternative size of Leeway may be required.
A
B
Next fasten the Velcro tabs (c) at the sides
to fit the Leeway to the user. An anterior,
neutral or posterior pelvic tilt can be achieved
depending on the clinical needs of the client.
C