Publicité
Les langues disponibles
Les langues disponibles
B
Connecting the cooker to the electrical system
NOTE
The appliance must only be connected to the electrical
system by an approved professional. You must not carry
out any modifications to the electrical system.
Indications for the installer
The device is configured at the factory for a single-phase AC power supply (230 V 1N ~ 50 Hz)
and equipped with a H05VV-F 3G 4 mm² connection cable connected to the terminal block.
The wires of the connecting cable are marked as follows : phase wire L - BN - brown, neutral
wire N - BU - blue, PE ground wire - GNYE - yellow + green.
You can configure the device for two-phase or three-phase (400 / 230V) power supply by
bridging the terminals of the terminal block according to the table and the connection
diagrams below, point 2 and point 3, then you must use a connection cable specified in the
Using the appliance
8
EN
Publicité
