Publicité
Les langues disponibles
Les langues disponibles
Inflate the Tire
EN
Check the tire pressure every month, and inflate the
tires if the pressure is too low. The recommended tire
pressure is 45-50 psi.
If there is a lack of air in the front and rear tires, you
may use the extended nozzle supplied with the scooter
to inflate tires. First connect the extension nozzle
with air pump, then unscrew the front (rear) tire valve
cap, and connect the extension nozzle and the valve
securely together, then Inflate the tire.
WARNING! Tire removal is very complicated. Please do
not remove the tire by yourself. Improper operation
may affect the operation of the scooter. Please contact
professional support.
Adjust the Mechanical Brake
Tool: 4 mm hex key (the tool needs to be prepared by
the user).
Before adjusting, make sure the scooter is turned off
and not charging. When the brake is too tight, use the
tool to turn the nut on the screw rod counterclockwise,
so as to slightly shorten the brake cable's exposed
bottom part. When the brake is too loose, use the tool
to turn the nut on the screw rod clockwise, so as to
slightly lengthen the brake cable's exposed bottom
part.
WARNING !
As with any mechanical component, a vehicle is subject to high stresses and wear. The various
materials and components may react differently to wear or fatigue. If the expected service life for a component
has been exceeded, it may break suddenly, therefore risking causing injuries to the user. Cracks, scratches and
discoloration in the areas subject to high stresses indicate that the component has exceeded its service life and
please contact an authorized or a specialized repairer.
21
Scooter Maintenance Schedule (Recommended)
Valve Cap
Maintaining the scooter regularly can help keep the scooter neat and in good condition, avoid safety hazards,
minimize breakdowns, slow down the deterioration of the scooter, and extend the scooter's service life.
Item
Tire Pressure
Tires
Tire Tread
Wear
Handlebar
Screws
Assembly
Service
Every
Every 3
Actions
Object
month
months
Inflate the tire until its
pressure reaches
√
45-50 psi.
Check whether the tire is
cracked, deformed, worn,
etc.
Tighten the screw that
connects the handlebar
assembly with the stem
√
assembly (with the
recommended torque of
4.8 ± 0.2 N·m).
Tighten the accelerator
screw (with the
Screws
recommended torque of
1.6 ± 0.1 N·m).
Tighten the brake
lever screw (with the
recommended torque of
5 ± 0.2 N·m).
EN
Every 500 km/
Every 1000 km/
Every 10000 km/
6 months
1 year
3 years
√
√
√
√
√
√
√
√
√
√
√
22
Publicité
