Safety Guidelines; Accessories; Scope Of Supply; Warning Notes - Weller COOPER Tools WHA 700 Manuel D'utilisation

Vacuum function
The vacuum is activated via the 2nd level of the foot switch (or optional manual operation
desk). The built-in metal plate at the nozzle outlet is used to transfer additional heat to the
component and, during the de-soldering process, must lie flat on top of the component. As a
result of the fact that the nozzle plate rests flat on the component, the vacuum tube is sealed
and the vacuum required for lifting is created. In the case of components which are uneven,
where the nozzle plate is not sealed, rubber suction inserts can be used.
Warning: When hot gas and vacuum are operated at the same time, hot air is sucked
in through the hot gas bit. In this operating state, make sure that the vacuum is sealed
by a component (desoldering process) or that the vacuum hose has been pulled out
from the unit.
Inert gas
Inert gas reduces oxidation and the flux remains active for longer. We recommend nitrogen
(N2), which is obtainable commercially in steel cylinders. The cylinder must be equipped
with a 0 - 10 bar pressure reducer. In addition a compressed air tube with an external
diameter of 6mm is required.
Warning: When using inert gas ensure that the surrounding area is adequately
ventilated.
Replacing nozzles
The hot gas nozzles are fastened to the heating element by a locking screw. If suction inserts
are used, these are simply put into the vacuum tube and can be easily replaced.
External sensor
It is possible to regulate the temperature with an external sensor (e.g. directly on the
component). To do this the unit must be supplemented by the "external sensor" kit (not
supplied as standard).

5. Safety guidelines

The manufacturer accepts no liability for usage other than that specified in the operating
instructions, nor for any unauthorised modifications.
These operating instructions and the warning information they contain should be read carefully
and kept in a clearly visible place adjacent to the soldering unit. Failure to adhere to warning
instructions could cause accidents and injuries or prove detrimental to health.
The WELLER WHA 700 hot air station complies with the EC certificate of conformity in
accordance with the basic safety standards of EC guidelines 89/336/EEC, 73/23/EEC and
89/392/EEC.

6. Accessories

Nozzle range - see page 51-54
5 87 367 80 Manual operation desk
5 87 369 17 Set external sensor
5 87 367 86 External sensor
5 15 048 99 Multiple rest for 6 nozzles

7. Scope of supply

WHA 700 control unit
Mains cable
Hot gas bit
Safety rest
Foot switch
Nozzle NO30 17.5 x 23.5
WHA nozzle changer
1 bag with: 3 cheese head screws - hexagon socket M3X5
Operating instructions
Illustration: exploded drawing - see page 55

8. WARNING NOTES

1. Keep your workplace tidy.
Always return the soldering equipment to its original holder, when it is not needed. Do not
place any combustible objects in the vicinity of the hot soldering equipment.
2. Please observe environmental influences.
Do not use the soldering equipment in moist or wet surroundings.
24