Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS / STEP 2 - HOW TO CUT
STEP 2: HOW TO CUT
Note: The arrows on the label on the back of each panel indicate the TOP of the Panel.
Steps 2 & 3 will be repeated when installing each of the 15 wall panels.
The following cutting instructions should be used when making all cuts.
2a. Carefully draw a line on the back of each panel where the cut is to be made. Any
adjustments for out of square or out of plumb should be considered when drawing this line.
Note: Using a straight edge when possible is highly recommended.
2b. Circular saw is recommended for making required cuts. If using utility knife, score the line
several times and then use locking pliers to snap off the excess piece as shown.
Note: If your installation is less than the full 96" height, you can trim the top of the top
panel(s). See installation for Panel (4), Panel (8), and Panel (12).
WARNING
UNDER NO CIRCUMSTANCES SHOULD THE TONGUE OR GROOVE EDGES BE
TRIMMED AS THIS MAY AFFECT WATERTIGHT STATUS OF THE FINAL INSTALLATION.
2
Cutting Width
Plumbing Cut-Outs:
Use a drill and the appropriate size hole saw to create cut-outs for the shower head, filler spout,
faucet handles and/or any other cutouts necessary for plumbing that is already in the walls.
Note: To be sure your measurements are correct, make a cardboard template to test the
plumbing cutouts prior to cutting the shower wall panels. Drill chuck can damage the
shower wall panel surface. Drill holes from back side of panel.
Cutting Height
7
Publicité
