Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION & FINISHING INSTRUCTIONS / STEP 18 / STEP 19
STEP 18: INSTALL RIGHT SIDE
WALL PANEL #12
18a. Locate Panel (12) Side Wall Panel and lay
it down on a flat surface.
18b. Based on your measurements from
Step 1 (How to Measure), make any
required plumbing cut-outs according to
theinstructions in Step 2 (How to Cut).
Note: If you are not using the full
width of the right side panels, cut
the left/inside end of the panels.
If your installation is less than the full 96"
height, you can cut down the top of
Panel (4) as needed.
18c. Repeat Steps 4c. - 4e.
STEP 19: CAULK CORNERS AND EDGES
19a. Properly caulk around the Shower Wall
System to insure a secure fit and finish.
This includes but is not limited to:
• Interior corners where shower walls meet
• Corners where the walls meet the base
• Outer edge of Side Wall Panels
• (Optional) Caulking along the top edge of
the entire enclosure is not required but
may help contribute to a finished look.
WARNING
Please keep the entire area dry for a
minimum of 24 hours to allow the caulk and
construction adhesive to properly cure.
18
19
18
Publicité
