Publicité
Les langues disponibles
Les langues disponibles
PREPARATION
INSTALLATION PROCEDURE:
The Shower Wall System can be installed over a variety of products. Consult with a professional
contractor if you intend to apply the panels to any surface other than those described here.
CEMENT/CONCRETE:
• Depending on the condition (flatness) of the existing wall, additional silicone may be required
to properly secure the wall panels to the substrate.
• Surface must be completely clean. This includes but not limited to: Soap scum, dust and any
other contaminates that may affect adhesion. Ceramic tiles do not need to be removed, if
solidly adhered.
• Recommended: The complete area must be sealed with two coats of water or oil-based sealer,
to ensure proper adhesion of the Shower Wall System.
• Complete the installation of the wall panels following the instruction manual, after the sealer
has completely dried.
MASONITE:
• Surface must be completely clean. This includes but not limited to: Soap scum, dust and any
other contaminates that may affect adhesion.
• Optional: The complete area sealed with two coats of water or oil-based sealer, to ensure
proper adhesion of the Shower Wall System.
• Complete the installation of the wall panels following the instruction manual, after the sealer
has completely dried.
OLD TILE:
IMPORTANT: All plastic tiles must be removed. Old ceramic tiles do not need to be removed, if
solidly adhered.
• Depending on the condition (flatness) of the existing wall, additional silicone may be required
to properly secure the wall panels to the substrate.
• Properly remove and or reattach any loose ceramic tiles.
• Remove all tile accessories attached to the wall. Surface must be completely clean. This
includes but not limited to soap scum, dust and any other contaminates that may affect adhesion.
• Complete the shower wall installation by following the instruction manual.
PLASTER:
• Additional silicone may be required to properly secure the substrate and the wall panel,
depending on the condition of the existing wall.
• Smooth all textured and/or swirled finishes by sanding.
• Surface must be completely clean. This includes but not limited to soap scum, dust and any
other contaminates that may affect adhesion.
• Recommended: The complete area must be sealed with two coats of water or oil-based sealer,
to ensure proper adhesion of the Shower Wall System.
• Complete the installation of the wall panels following the instruction manual, after the sealer
has completely dried.
SHEETROCK/GREENBOARD/CEMENT BOARD/ WOOD:
• Surface must be completely clean and free of soap scum, dust, and any other contaminates
that may affect adhesion.
• Optional: The complete area sealed with two coats of water or oil-based sealer, to ensure
proper adhesion of the Shower Wall System.
• Complete the installation of the wall panels following the instruction manual, after the sealer
has completely dried.
5
Publicité
