Suntec Wellness KLIMATRONIC COOLFIXX 3.5 Eco R290 Manuel D'utilisation page 17

Emptying of the water tank
•
As soon as the water tank is full, the "WF" blinks on the display,
the standby mode automatically turns on, it will sound the
warning alarm and all the buttons will be locked until the tank is
emptied.
•
Turn off the power and unplug the power cord. To empty of the
water tank you need to remove the rubber stopper on the
bottom of the unit and let the water leak into a container. Once
you reboot the device, it will work normally.
•
Continuous drainage (only in dehumidifying mode): Remove
the rubber stopper on the bottom of the unit and connect the
drainage hose to the opening. Let the water leak into a
container (pic.5).
Cleaning
•
Always disconnect the appliance from the power outlet and
let it cool before cleaning. Never immerse the appliance in
water to prevent electric shocks.
•
Wipe over the exterior of the appliance with a soft wet cloth
and neutral detergent and then wipe dry with a dry cloth.
•
Do not use gasoline or other chemicals to clean the unit.
•
Clean the dust filter once every two weeks. Clean the dust
filter with neutral detergent and about 40°C water. Rinse off
any detergent, then let it air-dry before inserting it back into
the unit (pic.6).
•
If you do not use the unit for a longer time, empty the water
tank completely. Make sure that the unit is disconnected
from the power supply and that it is clean. Keep the unit
covered in a dry place.
Troubleshooting
Problem
1. Unit does not start
when pressing
"POWER".
2. It's not cool
enough.
Possible causes
Water tank is full and indicating light
"W.F." is blinking.
Room temperature is lower than the set
temperature during operation mode
cooling.
The ambient temperature is too low or
too high.
In dehumidification mode, the ambient
temperature is too low.
Doors or windows are not closed.
There are heat sources in the room.
Exhaust hose is not installed or blocked.
Set temperature is too high.
Pic.6
Suggestions
Empty the water tank.
Reset the temperature.
We recommend the operaiton at 7-35°C.
The ambient temperature needs to be
higher than 17°C.
Close all doors and windows.
Remove the heat sources if possible.
Install the exhaust hose and make sure
that the hose is clean and not blocked by
any objects.
Reset the temperature.
Pic.5