emerio WK-122227 Mode D'emploi page 6

WK-122227
HOUSEHOLD USE ONLY
PARTS DESCRIPTION
1. Lid
2. Handle
3. Water gauge
4. On/off switch (a) and adjustable
temperature control (b)
5. Power base
6. Water inlet
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you clean your kettle before use by boiling
a full kettle of water twice and then discarding the water.
OPERATION OF YOUR KETTLE
1. Make water directly run through the water inlet at the center of the lid (the strong water flow can push
the cover of the water inlet to open automatically), or open the lid and fill with the desired amount of
water to the water kettle. Always fill the kettle between the minimum (0.5L) and maximum (1.7L) marks.
Too little water will result in the kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling.
Ensure that the lid is firmly in place before connecting the power cord to the outlet.
2. Connect the plug into a power outlet. Press the on/off switch button "
kettle starts to boil the water. The LED light will be shining in red. The kettle will switch off automatically
once the water has boiled. You can shut off the power by pressing the switch button again at any moment
during boiling water.
NOTE: Ensure that switch is clear off obstructions and the lid is firmly closed all the time throughout the
boiling cycle. The kettle will not turn off if the switch is constrained and scalding may occur if the lid is
open.
3. Take the plug out of the outlet. Lift the kettle then pour the water.
NOTE: operate carefully when pouring the water from your kettle as boiling water will scald.
4. The kettle will not re-boil until the switch is pressed again. Allow to cool for 30~40 seconds before
reopening to boil water.
NOTE: Ensure power supply is turned off when kettle is not in use.
5. Should you accidentally allow the kettle to operate without water; the boil-dry protection will
automatically switch it off. If this occurs, allow the kettle to cool before filling with cold water and
re-boiling.
Advanced operation:
1. Keep warm function:
Press the On/off Switch for 3 seconds; the kettle will be shining with red light on and off. After the water
boils, the kettle will keep it warm for 2 hours and go on heating when the temperature drops below 85°C.
2. Temperature showing by LED display:
Use the adjustable temperature control "
desired temperature reaches, the kettle will stop heating.
60°C: Green light.
" to choose the desired water temperature. When the
- 5 -
EN
" on the handle and the