Power Fist 9094996 Mode D'emploi page 9

V1.0
1. Place the jack on a hard level surface capable
of handling the load.
2. Close the release valve. Insert the slotted end
of the handle over the valve and twist to the
right.
3. Insert the upper handle into the lower handle.
Insert the handle into the handle receiver.
4. Pump to raise the saddle. Stop just before the
saddle contacts the load' s lift point. Inspect the
saddle' s position and adjust if necessary.
5. Turn the extension screw to the left to raise the saddle until it contacts
the load.
6. Pump slowly until the saddle is supporting the load. Continue to pump
as normal to lift the load slightly higher than the desired height to allow
placement of the supports.
7. Position supports, like jack stands, if the load will remain above ground
for an extended period. Consult the support device's manual for proper
placement. Also consult the section Raising and Lowering a Vehicle.
8. Twist the valve to the left slowly to allow the ram to retract. Gradually
lower the load onto the supports.
9. Once the supports are carrying the load, open the valve to allow the ram
to retract fully.
LOWERING A LOAD
WARNING! Dynamic shock loads are created by quick opening and
closing of the release valve when lowering the load. The resulting
overload may cause the hydraulic system to fail, which could result
in severe personal injury and/or property damage.
WARNING! Before lowering the load or vehicle, ensure that there are no
obstructions underneath and that all people are standing clear.
1. Insert the slotted handle end over the release valve.
2. Open the valve by gradually twisting to the left. The load will begin to
lower.
3. Twist right to slow and left to increase the rate of descent.
4. Lower the extension screw by turning it clockwise.
Page 9
MULTI-POSITIONAL HYDRAULIC BOTTLE JACK
www.princessauto.com / 1-800-665-8685
9094996
Figure 2.