Publicité
Les langues disponibles
Les langues disponibles
use charger indoors and charge battery at
room temperature (22 C or +70 F)
whenever possible. Do not charge battery
longer than 72 hours because damage could
result.
Disposing of Battery
(Electric start models only)
DO NOT PLACE USED BATTERIES IN YOUR
REGULAR TRASH!
THIS SEALED LEAD (ACID) BATTERY MUST
BE COLLECTED, RECYCLED OR DISPOSED
OF IN AN ENVIRONMENTALLY SOUND
MANNER.
The incineration, landfilling or mixing of sealed lead
(acid) batteries with the municipal solid waste stream
is PROHIBITED BY LAW in some areas.
Return this battery to a federal or state approved
sealed lead (acid) battery recycler. THis may be
where you purchased the battery.
Contact your local waste management officials for
other information regarding the environmentally
sound collection, recycling and disposal of this
battery.
Cleaning
Underside of Mower Housing
To ensure best performance, keep underside of mower
housing clean. Be especially careful to keep kickers
free of debris (Fig. 21).
Washing Method
Whenever the underside of the mower requires
cleaning, follow this procedure for washing debris out
from underside of deck.
1.
Position mower on a flat concrete or asphalt
surface near a garden hose.
2.
Start the engine.
EN–16
3.
Hold the running garden hose at handle level and
direct water to flow on ground just in front of
right rear tire (Fig. 22). The rotating blade will
draw water under the housing and wash out
clippings. Let the water run for a few minutes or
until you no longer see clippings being washed
out from under housing.
4.
Stop the engine.
5.
Turn off the garden hose.
6.
Restart mower and let it run for a few minutes to
dry out moisture on the mower and its
components. While the engine is running,
engage and disengage the traction drive several
times to dry it out.
Scraping Method
If washing does not remove all debris from under
deck, tip mower and scrape it clean.
1.
Stop engine and pull wire off spark plug (Fig. 9).
2.
Drain gasoline from fuel tank. See Drain
Gasoline section.
3.
Tip mower on its left side (Fig. 17).
4.
Remove dirt and grass clippings with a
hardwood scraper. Avoid burrs and sharp edges.
5.
Turn mower upright.
6.
Refill gas tank.
7.
Reconnect spark plug wire.
Belt Cover
Keep area under belt cover free of debris.
1.
Stop the engine.
2.
With engine turned off, remove bolts securing
belt cover (Fig. 23) to mower housing.
3.
Lift off cover and brush out all debris from belt
area.
4.
Reinstall belt cover.
Publicité
