Publicité
Les langues disponibles
Les langues disponibles
10.6
log placement
WARNING
!
WARNING
!
•
Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
•
Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
•
Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
with this appliance may result in property damage or personal injury.
appliance may not function properly and delayed ignition may occur.
•
Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
•
The logs are fragile and should be handled with care.
appliance may not function properly and delayed ignition may occur.
•
The logs are fragile and should be handled with care.
"PHAZER™ logs [and glowing embers], exclusive to Napoleon/Continental, provide a unique and realistic
PHAZER™ logs and glowing embers, exclusive to Timberwolf, provide a unique and realistic glowing effect that is
glowing effect that is different in every installation. Take the time to carefully position the glowing embers for a
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
"PHAZER™ logs [and glowing embers], exclusive to Napoleon/Continental, provide a unique and realistic
maximum glowing effect. Log colours may vary. During the initial use of the appliance, the colours will become
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour pig-
glowing effect that is different in every installation. Take the time to carefully position the glowing embers for a
more uniform as colour pigments burn in during the heat-activated curing process."
ments burn in during the heat-activated curing process.
maximum glowing effect. Log colours may vary. During the initial use of the appliance, the colours will become
more uniform as colour pigments burn in during the heat-activated curing process."
Insert only if
applicable ---->
Insert only if
applicable ---->
Log Number
Log Number
Log Number
1
1
1
2
2
2
3
3
3
4
4
4
5
5
5
6
6
6
7
7
8
8
9
9
10
10
Studs
(Log #2)
IF APPLICABLE, INSERT DRAWING OF BURNER/SUPPORT WITH APPROPRIATE LA-
IF APPLICABLE, INSERT DRAWING OF BURNER/SUPPORT WITH APPROPRIATE LA-
IF NOT APPLICABLE, HIDE THIS SECTION AND USE BOXES BELOW.
IF NOT APPLICABLE, HIDE THIS SECTION AND USE BOXES BELOW.
Holes under log
(not illustrated).
If applicable, insert the following statement:
If applicable, insert the following statement:
note:
Log numbers are located on the bottom or back of the logs.
note:
Log numbers are located on the bottom or back of the logs.
Part Number
Part Number
Part Number
W135-0930
W135-0931
W135-0932
W135-0933
W135-0934
W135-0935
Stud
Burner
(Log #1)
Ports
A1
B2
B1
BELS (I.E. STUDS, PILOT SHIELD, BURNER PORTS, ETC.).
BELS (I.E. STUDS, PILOT SHIELD, BURNER PORTS, ETC.).
Media
Tray
Description
Description
Description
Rear log (#1)
Left middle log (#2)
Right middle log (#3)
Left crossover log (#4)
Right crossover log (#5)
Right front log (#6)
Pilot Shield
Stud
(Log #1)
A2
C2
C1
Media
Tray Edge
Holes under log
finishing
EN
Studs
(Log #3)
D1
Stud
(Log #5)
55
W415-2881 / C / 03.07.22
Publicité
