Hotpoint Ariston NEBL1 V D Serie Mode D'emploi page 25

Installation
! Before placing your new appliance into operation please read
these operating instructions carefully. They contain important
information for safe use, for installation and for care of the
appliance.
! Please keep these operating instructions for future reference.
Pass them on to possible new owners of the appliance.
Positioning and connection
Positioning
1. Place the appliance in a well-ventilated humidity-free room.
2. Do not obstruct the rear fan grills. The compressor and
condenser give off heat and require good ventilation to operate
correctly and save energy.
3. Leave a space of at least 10 cm between the top part of the
appliance and any furniture above it, and at least 5 cm between
the sides and any furniture/side walls.
4. Ensure the appliance is away from any sources of heat (direct
sunlight, electric stove, etc.).
5. In order to maintain the correct distance between the appliance
and the wall behind it, fit the spacers supplied in the installation
kit, following the instructions provided.
Levelling
1. Install the appliance on a level and rigid floor.
2. If the floor is not perfectly horizontal, adjust the refrigerator by
tightening or loosening the front feet.
Electrical connections
After the appliance has been transported, carefully place it
vertically and wait at least 3 hours before connecting it to the
electricity mains. Before inserting the plug into the electrical socket
ensure the following:
• The appliance is earthed and the plug is compliant with the law.
• The socket can withstand the maximum power of the appliance,
which is indicated on the data plate located on the bottom left
side of the fridge (e.g. 150 W).
• The voltage must be in the range between the values indicated
on the data plate located on the bottom left side (e.g. 220-
240V).
• The socket is compatible with the plug of the appliance. If
the socket is incompatible with the plug, ask an authorised
technician to replace it (see Assistance). Do not use extension
cords or multiple sockets.
! Once the appliance has been installed, the power supply cable
and the electrical socket must be easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced by authorised
technicians only (see Assistance).
! The manufacturer declines any liability should these safety
measures not be observed.
Start-up and use
Starting the appliance
! Before starting the appliance, follow the installation
instructions (see Installation).
! Before connecting the appliance, clean the compartments
and accessories well with lukewarm water and bicarbonate.
! The appliance comes with a motor protection control system
which makes the compressor start approximately 8 minutes
after being switched on. The compressor also starts each time
the power supply is cut off whether voluntarily or involuntarily
(blackout).
1. Insert the plug into the socket and switch on the product
using the appropriate button, ensure that yellow refrigerator
and freezer temperature lights illuminates
2. After a few hours you will be able to put food in the
refrigerator.
3. Press the button (rapid freezing): the
QUICK FREEZE
indicator light will illuminate. Once the refrigerator
FREEZE
has reached the optimal temperature, the indicator light
goes out and you can begin food storage.
Using the refrigerator to its full potential
• Adjust the temperature using the display.
• Activate the
QUICK FREEZE
quickly, for example, when you place a large number of new
food items inside a fridge and the internal temperature rises
slightly. This function quickly cools the groceries by temporarily
reducing the temperature until it reaches the ideal level.
• Place only cold or lukewarm foods in the compartment, never
hot foods (see Precautions and tips).
• Remember that cooked foods do not last longer than raw
foods.
• Do not store liquids in open containers: they will increase the
level of humidity in the refrigerator and cause condensation
to form.
SHELVES: with or without grill.
Due to the special guides the shelves are removable and the
height is adjustable , allowing easy storage of large containers
and food. Height can be adjusted without complete removal of
the shelf.
TEMPERATURE Indicator light*: to identify the coldest area in
the refrigerator.
1. Check that OK appears clearly on the indicator light (see
diagram).
2. If the word "OK" does not appear it means that the temperature
is too high: set a lower temperature and wait approximately 10
hours until the temperature has been stabilised.
3. Check the indicator light again: if necessary, readjust it
following the initial process. If large quantities of food have
been added or if the refrigerator door has been opened
frequently, it is normal for the indicator not to show OK. Wait at
least 10h before you set the FRIDGE WORKING temperature
on a lower position.
AIR *
It is recognizable due to the presence of the mechanism on the
top part of the refrigerator compartment (see diagram).
B
A
AIR maximises air circulation, improving the efficiency of the
evaporator and helping to achieve the optimal temperature inside
the refrigerator as quickly as possible each time it has been
QUICK
function to lower the temperature
GB
25