Kenwood FP880 Serie Manuel D'utilisation page 4

safety
The blades and discs are very sharp, handle with care.
Always hold the knife blade by the finger grip
k at the top, away from the cutting edge, both
a
when handling and cleaning.
Do not lift or carry the processor by the handle - or the handle may break
resulting in injury.
Always remove the knife blade before pouring contents from the bowl.
Keep hands and utensils out of the processor bowls whilst connected to the
power supply.
Switch off and unplug:
before fitting or removing parts
after use
before cleaning
Never use your fingers to push food down the feed tube. Always use the
pusher/s supplied.
Before removing the lid from the bowl whilst on the power unit:-
switch off;
wait until the attachment/blades have completely stopped;
Do not use the lid to operate the processor, always use the on/off speed control.
This machine will be damaged and may cause injury if the
interlock mechanism is subjected to excessive force.
This machine is not intended for use by young children or infirm persons without
supervision.
Never use an unauthorised attachment.
Don't let children play with this machine.
Never leave the machine on unattended.
Never use a damaged machine. Get it checked or repaired: see 'service'.
Never let the power unit, cord or plug get wet.
Don't let excess cord hang over the edge of a table or worktop or touch hot
surfaces.
Never misuse your food processor and only use it for its intended domestic use.
Do not exceed the maximum capacities stated.
Do not operate the processor continuously for more than 10 minutes without a
rest period - or the motor may cut out.
The motor will automatically cut out if the machine is overloaded or run for too
long. If this occurs press the "0" off button and allow the machine to cool down
for approximately 30 minutes. Once the motor has cooled sufficiently it will
operate normally again.
before plugging in
Make sure your electricity supply is the same as the one shown on the
underside of your machine.
This appliance complies with European Economic Community Directive
89/336/EEC.
before using for the first time
1 Remove all packaging including the plastic blade covers from the knife blade.
Take care the blades are very sharp. These covers should be discarded
as they are to protect the blade during manufacture and transit only.
2 Wash the parts see 'cleaning'
3 Push excess cord into the back of the machine.
key
processor
power unit with fixed drive shaft
detachable drive shaft
bowl
lid
feed tube
pushers
safety interlock
cord storage
pulse control
on/off control
additional attachments
k a
Not all of these attachments listed below will be included with your food
processor. Please refer to your content list supplied. To buy an attachment not
included in your pack, contact the dealer from whom you purchased your
appliance.
knife blade
dough tool
twin beater geared metal whisk
maxi-blend canopy
thick slicing/coarse shredding disc
thin slicing/fine shredding disc
fine (Julienne style) chipper disc
extra coarse shredding disc
rasping disc
standard chipper disc
k geared citrus press
21
k mini processor bowl
22
k spatula
23
k disc storage box
24
k recipe book
25
to use your food processor
1 Fit the detachable shaft over the power unit fixed shaft
2 Then fit the bowl. Place the handle towards the back and turn clockwise until it
locks
3 Fit an attachment over the drive shaft.
Always fit the bowl and attachment onto the machine before adding ingredients.
4 Fit the lid
Do not use the lid to operate the processor, always use the on/off
control.
5 Press the "I" button to switch on.
The processor won't work if the bowl and lid are fitted
incorrectly.
Use the pulse control for short bursts. The pulse will operate for as long as the
lever is held down.
6 Reverse the above procedure to remove the lid, attachments and bowl.
Always switch off "0" before removing the lid.
Do not operate the processor continuously for more than 10
minutes without a rest period - or the motor may cut out.
The motor will automatically cut out if the machine is overloaded
or run for too long. If this occurs press the "0" off button and
allow the machine to cool down for approximately 30 minutes.
Once the motor has cooled sufficiently it will operate normally
again.
important
Your processor is not suitable for crushing or grinding coffee beans, or
converting granulated sugar to caster sugar.
When adding almond essence or flavouring to mixtures avoid contact with the
plastic as this may result in permanent marking.
maximum capacities
Shortcrust pastry Flour wt
Yeast dough Flour wt
One Stage Cake Total wt
Chopping meat Total wt
Liquid with canopy
Twin geared whisk
Mini processor bowl
using the attachments
knife blade/
The knife blade is the most versatile of all the attachments. The length of the
processing time will determine the texture achieved. For coarser textures use
the pulse control.
Use the knife blade for cake and pastry making, chopping raw and cooked
meat, vegetables, nuts, pate, dips, pureeing soups and to also make crumbs
from biscuits and bread. It can also be used for yeasted dough mixes if the
dough tool is not supplied.
Use the dough tool for yeasted mixes.
2
.
- ensuring the top of the drive shaft locates into the centre of the lid.
340g/12oz
600g/1lb 6oz
1.5Kg/3lb 5oz
600g/1lb 6oz
1.5litres/2pts 12fl.oz
6 egg whites
200g/8oz
dough tool
.