Publicité
Les langues disponibles
Les langues disponibles
Remove the Presta valve adapter and return to the on-
board storage area on the battery foot side of the unit.
Remove the high pressure hose and store in the hose
wrap on the battery foot side of the in ator.
To use the spreader nozzle, standard pinch valve adapter,
or the narrow pinch valve nozzle:
Insert the accessory into the front end of the high volume
hose, making sure the accessory is firmly in place.
NOTE: The narrow pinch valve nozzzle is slimmer to fit
the smaller holes.
To remove, hold the accessory and pull from the hose.
INFLATING WITH THE HIGH PRESSURE
HOSE AND ACCESSORIES
See Figures 11 - 13, page 13.
The high pressure hose can be used with the provided adap-
tors to in ate a variety of items.
To install the valve, thread adaptor, or needle into the air
chuck. In ate to desired pressure.
To remove, unscrew the accessory from the air chuck
then hold the accessory and pull from the hose.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts can create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
NOTE: ILLUSTRATIONS START ON PAGE 11 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
ACCESSORIES STORAGE
See Figures 14 and 16, page 13.
When not in use, the accessories can be stored in the
onboard storage located on the in ator, or in the included
drawstring bag.
Store the Presta valve adapter, sports ball needle, and
pinch valve adapter in the onboard storage located on
the battery foot side of the in ator.
Store the standard pinch valve nozzle in the onboard
storage on the back side of the in ator.
Store the narrow pinch valve nozzle, the spreader nozzle,
and the standard pinch nozzle in the drawstring bag.
HOSE STORAGE
See Figures 14 -15, page 13.
When in ator is not in use, the high pressure and high volume
hoses can be stored in the hose wraps located on the in ator.
Wrap the high pressure hose around the battery foot and
snap the hose into the two clips for a secure fit.
Wrap the high volume hose around the back of the in a-
tor. Line up the center of the hose and press into the clip
until it snaps into place then press the two ends of the
hose until you hear a click for a secure fit.
MAINTENANCE
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
Do not at any time let brake uids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which can result in serious personal injury.
8 — English
WARNING:
Publicité
