fadini Junior 650 Notice D'instructions page 29

JUNIOR 633
JUNIOR 650
ELECTRICAL CONNECTIONS TO THE TERMINALS AND THEIR FUNCTIONS
Accessory
Connections for n° 2
Junior 633 or Junior 650
sliding gate operators
2
1
Master Slave
n° 4x1
Output for courtesy
lamp relay
max 24 Vdc - 50 mA
Pedestrian input
NC contact for
nd
2 Junior input
Flashing lamp
230 Vac - 25 W max
ELPRO 65
Electrical connections
It is important to determine which Elpro 65
!
MASTER will command and control the Elpro 65
SLAVE. All the accessories for command,
signalling and safety must be connected to the
terminals of the Elpro 65 MASTER that manages
and controls the entire system. If the gates aren't
of the same length, the Elpro 65 MASTER is to be
mounted on the longest one.
Carry out the following connections:
Elpro 65 SLAVE
Elpro 65 MASTER
dip-switch 12 = ON:
dip-switch 12 = OFF:
terminal 15 (open) terminal 4 (open)
terminal 5 (close)
terminal 16 (close)
terminal 3 (common)
terminal 17-23 (common)
terminal 22 terminal 16 (close)
terminal 17 jumper with 23
terminal 1 jumper with 2
terminal 3 (common) jumper with
Master
15 16 17 20 21 22 23 24
23
17
A 4-wire cable is necessary for the connection
between the two Elpro 65 programmers
Output for courtesy lamp relay
18 19
max 24 Vdc - 50 mA
20 23
NO input for external contact for
pedestrian opening
22 23
Pre-fitted jumper. NC contact for
connection to 2
25 26
OUTPUT 230 Vac - 25 W max for flashing lamp
Dip-switches and LED indication of their functions
DIP-SWITCH 12
12
6 (stop)
1 2 3 4 5 6
3
PROGRAMME JUNIOR MASTER AND SLAVE
!
SEPARATELY
CONNECTIONS HAVE BEEN MADE AND THE
DIP-SWITCHES SET CORRECTLY
nd
Junior
DIP-SWITCH 4 and 8
4
8
29
nd
ON: Elpro 65 SLAVE (2 Junior 633/Junior 650)
OFF: Elpro 65 MASTER (1 st Junior 633/Junior 650)
Refer to the previous pages for the
! dip-switch arrangements relative to the
individual accessories and functions.
L21, L22, L24 green = ON
with both programmers to confirm proper
communication between the two Elpro 65s
Slave
15 16 17 20 21 22 23 24
ONCE THE
Pedestrian trimmer: the opening
distance of the gate is adjusted up to
3 metres.
In Automatic function (dip 3 = ON,
closes after pause time completed)
ON: pre-flashing before opening
OFF: without pre-flashing
ON: flasher desactivated during pause in
automatic operation (with dip 3 = ON)
OFF: it flashes during pause in automatic
operation (with dip 3 = ON)
ELECTRICAL